Toyota SXE10 Altezza 3S-GE Beams 6 Speed Manual Conversion Set 3S J160

OEM factory 6 speed manual conversion complete set as removed from a SXE10 chassis Toyota Altezza.

Includes all parts pictured;
- Complete J160 6 speed gearbox with shifter, clutch fork, throwout bearing, crossmember
- Dual mass flywheel & bolts (no clutch included as it was worn)
- Complete brake and clutch pedal assemblies
- Clutch master cylinder
- Complete clutch hard & soft lines + clutch slave cylinder
- Backing plate or sandwich plate
- Speedo drive unit
- Tunnel cut & rubber floor boots
- Factory manual drive shaft
- Interior shifter surrounding trim & boot
- Factory manual gauge cluster
- Manual steering wheel
- Misc bolts and hardware required for conversion



Condition: Good used condition as pictured, the gear shifter boot is not attached to the surround so will need some work in that area to be tidy. This gearbox had three worn syncros when we tested it on our rolling road dyno, the fluid was clean and in good condition when drained. We have sent this gearbox away to a specialist gearbox shop where it was stripped and inspected and had those three syncros replaced with genuine Toyota parts and reassembled, all bearings were still in good condition on inspection so were not replaced at this time. Removed from a vehicle with 255,000km on the odometer however box has some markings indicating it had already been replaced in the donor vehicle, hence it is hard to put exact number of km traveled on the gearbox alone.

For warranty terms and conditions please see the Warranty Info

For all other information including delivery and handling times please see the FAQs or contact us at the details below

While we can send the majority of items internationally this item only has NZ shipping prices, if you are located overseas and would like to purchase this item then please contact us for a quote.