JDM Honda Access 4G Prelude Front Corner Parking Sensor Wiring & Switch 92-96

OEM factory optional Honda Access factory optional front corner sensor wiring harness with control unit, as removed from a BB1 chassis Honda Prelude, years 1992 - 1996.

- This front loom set has an interior and exterior harness. The interior loom plugs into the option ports in the interior fuse box & the switch mounts in an available switch blank. There are two wires which will need to be extended from the interior loom to the exterior loom (yellow wires in brown plugs), these wires are built into Japanese market vehicle but will need to be run on any other market vehicle as far as we are aware.
- The front exterior loom has piggy back plugs which connect to the brake master cylinder fluid switch, this is so the front sensors will only function when the switch is on and the parking or e brake is released. There is another wiring plug in the engine bay which this loom connects to with piggy back plugs. There is a relay box to control the parts which usually mounts behind the bumper.

There are no sensors included with this set but the sensor part numbers are below as it should be possible to find some replacements or even newer sensors could work if they are the three wire type.
These use:
- sensor part number 08V66-SP1-0M0-03 & 08V66-SP1-060-B3
- control unit part number 08V67-SL4-0M1-01 

Please NOTE: this set best suits those with prior knowledge of working with wiring and electronics as there could be quite a bit to work out depending on your knowledge level and the vehicle it is being fitted to.

Condition: Good used condition as pictured, this was bench tested with a pair of sensors and all functions are working well.